PDF《www.philips.com/welcome》

4239.

000.7223.4 GC1900 series Register your product and get support at www.philips.com/welcome A B C D E F G I H J N K O M L

1 2

3 4

5 6

7 8

9 10

11 12

13 14

15 16

2 1

17 18

19 20

21 22

23 English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. General description?(Fig.?1) A Spray nozzle (all types except GC1903/GC1910)? B Cap of filling opening C Steam control - - ?O= no steam - - small cloud = minimum steam - - large cloud = maximum steam - - x = Calc-clean position D Spray button 8?(all types except GC1903/GC1910) E Steam boost button ?(all types except GC1903/GC1905/GC1910/ GC1920) F Automatic shut-off light (GC1990/GC1991 only) G Temperature dial H Double-Active Calc System (all types except GC1903/GC1905/ GC1910/GC1920) I Temperature light J Mains cord K Type plate L Water tank M MAX water level indication N Soleplate O Heat-resistant storage cover (GC1981/1991 only) Important Read this user manual carefully before you use the appliance and save it for future reference. Danger - - Never immerse the iron in water. Warning - - Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. - - Do not use the appliance if the plug, the mains cord or the appliance itself shows visible damage, or if the appliance has been dropped or?leaks. - - If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. - - Never leave the appliance unattended when it is connected to the mains. - - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - - Children should be supervised to ensure that they do not play with the appliance. - - Do not let the mains cord come into contact with the hot soleplate of the iron. Caution - - Only connect the?appliance to an earthed wall socket. - - Check the mains?cord regularly for possible damage. - - The soleplate of the iron can become extremely hot and may cause burns if touched. - - When you have finished ironing, when you clean the appliance, when you fill or empty the water tank and also when you leave the iron even for a short while: set the steam control to position O, put the iron on its heel and remove the mains plug from the wall socket. - - Always place and use the iron on a stable, level and horizontal surface. - - Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the water tank. - - This appliance is intended for household use only. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and?according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Before first use

1 Remove any sticker or protective foil from the soleplate.

2 Let the iron heat up to maximum temperature and pass the iron over a piece of damp cloth for several minutes to remove any residues from the soleplate. Using the appliance Filling the water tank This iron is designed to be used with tap water. If the tap water in your area is very hard, we advise you to mix it with an equal amount of distilled water. Do not use distilled water only. Do not put perfume, vinegar, starch, descaling agents, ironing aids, chemically descaled water or other chemicals in the water tank.

1 Switch off the appliance and unplug it.

2 Set the steam control to position O (= no steam)?(Fig.?2).

3 Open the cap of the filling opening?(Fig.?3).

4 Tilt the iron and fill the water tank up to maximum level under the tap?(Fig.?4). Note: Do not fill the water tank beyond the MAX indication.

5 Close the cap of the filling opening ('

click'

). Selecting?temperature and?steam setting Fabric type Temperature setting Steam setting Steam boost (specific types only) Spray (specific types only) Linen MAX large cloud Yes Yes?

8 Cotton

3 large cloud Yes Yes

8 Wool

2 small cloud No Yes

8 Silk

1 O No No Synthetic fabrics (e.g.Acrylic, nylon, polyamide, polyester).

1 O No No Check the laundry care label of the article to be ironed to determine the required ironing temperature. If you do not know what kind or kinds of fabric an article is made of, determine the right ironing temperature by ironing a part that?is not visible when you wear or use the article. Silk, woollen and synthetic materials: iron the reverse side of the fabric to prevent shiny patches.Avoid using the spray function to prevent stains.

1 To set the appropriate ironing temperature,?turn the temperature dial to the appropriate position (see the table above)?(Fig.?5).

2 Put the iron on its heel.

3 Put the mains plug in an earthed wall socket. , , The temperature light goes on. Do not set the steam control to a steam setting if you have set a low?ironing temperature (below 2/ WOOL setting) or when the iron is still heating up (as long as the temperature light is on).?Otherwise water will?leak from the iron.

4 When the temperature light?goes out, wait a while before you start ironing. , , During ironing, the temperature light goes on from time to time.This indicates that the iron is heating up to the set temperature.

5 Set the appropriate steam setting. Make sure that the steam setting you select is suitable for the set ironing temperature: - - O for no steam (for all temperature settings). ?(Fig.?2) - - small cloud?for minimum steam (temperature settings?

2 and 3. ?(Fig.?6) - - large cloud for maximum steam (temperature settings?

3 to MAX. ?(Fig.?7) Features Spray function (specific types only) You can use the spray function at any temperature to moisten the article to be ironed.This helps remove?stubborn creases.

1 Make sure that there is enough water in the water tank.

8 Pull the steam control slightly upwards and gently shake the iron until all water in the tank has been used up?(Fig.?16). , , Steam and boiling water come out of the soleplate. Scale (if any) is flushed out.

9 After you have used the Calc-Clean function, press down the steam control while you turn it to position O. ?(Fig.?17) Note: Repeat the Calc-Clean process if the water that comes out of the iron still contains scale particles. After the Calc-Clean process

1 Put the plug?in the wall socket and let the iron heat up to let the soleplate?dry.

2 Unplug the iron when the temperature light goes out.

3 Move the iron gently over a piece of used cloth to remove any water stains that may have formed on the soleplate.

4 Let the iron cool down before you store it. Cleaning the steam control needle

1 Pull the steam control out of the appliance. ?(Fig.?18)

2 Use vinegar to remove scale, if any, from the needle?(Fig.?19). Do not bend or damage the steam control needle.

3 Reinsert the steam control. Place the point of the needle exactly in the centre of the hole and fit the small projection on the side of the needle into the slot?(Fig.?20).

4 Set the steam control to position O. Storage

1 Set the steam control to position O and remove the plug from the wall socket.

2 Wind the mains cord round the cord storage facility?(Fig.?21).

3 Specific types only: put the?iron in the heat-resistant storage cover and fasten the cover with theVelcro strips?(Fig.?22). Note: If you use the heat-resistant soleplate cover, you do not have to let the iron cool down first. If you want to store the iron without the soleplate cover, let it cool down first. Environment - - Do not throw away?the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, ?you help to preserve the environment?(Fig.?23). Guarantee and service If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your countr........