PDF《www.philips.com/welcome》

click'

)?(Fig.?11). Every two months: shaving heads

1 Switch off the shaver.

2 Press the release button (1) and remove the shaving unit (2)?(Fig.?9).

3 Push the sides of the central spring towards each other (1) and then lift the retaining frame out of the shaving unit (2)?(Fig.?12).

4 Slide the shaving heads out of the retaining frame. Hold your finger underneath the shaving head to prevent the cutter from falling out.

5 Disassemble and clean the shaving heads one by one?(Fig.?13). Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored.

6 Clean the cutter with the short-bristled side of the cleaning brush?(Fig.?14). Brush carefully in the direction of the arrow.

7 Clean the guard with the?cleaning brush?(Fig.?15).

8 Slide the shaving heads back into the retaining frame and put the retaining frame back into the shaving unit.

9 Put the shaving unit back onto the shaver?(Fig.?11). Tip: For extra thorough cleaning, clean the shaving heads by putting them in a degreasing liquid (e.g. alcohol) every six months.To remove the shaving heads, follow steps

1 to

4 described above.After cleaning, lubricate the central point on the inside of the guards with a drop of sewing machine oil to prevent wear of the shaving heads. Storage - - Always put the protection cap on the shaver after use, to prevent damage?(Fig.?7). Replacement Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ4 ? Philips shaving heads only.

1 Switch off the shaver.

2 Press the release button (1) and remove the shaving unit (2)?(Fig.?9).

3 Push the sides of the central spring towards each other (1) and then lift the retaining frame out of the shaving unit (2)?(Fig.?16).

4 Slide the shaving heads out of the retaining frame.

5 Slide new shaving heads into the retaining frame?(Fig.?17).

6 Put the retaining frame back into the shaving unit?(Fig.?11).

7 Put the shaving unit back onto the shaver ('

click'

). Accessories To retain the top performance of your shaver, make sure you clean it regularly and replace its shaving heads at the recommended time. Shaving heads - - We advise you to replace your shaving heads every two years.Always replace with HQ4 ? Philips shaving heads. ?(Fig.?18) Cleaning - - Use Cleaning Spray (HQ110, not available in some countries) to clean the shaving heads thoroughly. Environment - - Do not throw away the appliance?with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you?help to preserve the environment?(Fig.?19). - - Batteries contain substances that may pollute the environment. Do not throw away empty batteries with the normal household waste, but dispose of them at an official collection point for batteries.Always remove the batteries before you discard and hand in the appliance at an official collection point?(Fig.?20) Guarantee and service If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Consumer Care Centre in your country (you?find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance.?If you are unable to solve the problem with the information below, contact the Consumer Care Centre in your country.