DOC《压管机使用说明书》

三、操作 1.? 机器初次使用时应空扣压20~30次,观察各部位均正常后方可使用.锁管机在冬季使用时应空载扣压20-30次,以使油温增高一些. 2.? 按下开模按钮,打开模具座.根据所扣压胶管规格选用相应的模具安装在模座上,并调整标尺刻度.(详见技术参数参考表) 3.? 把带有接头的胶管置于锁头内适当位置,使得一次扣压全部长度. 4.? 按下扣压按钮执行扣压操作,直至锁头停止扣压为止. 5.? 按下开模按钮,取出扣压成的胶管总成.用游标卡尺检测扣压后的管套外径尺寸,如与参数表不符,应精调标尺刻度,并重复上述操作,直到符合要求为止. C operation 1. Initial use of the machine should be free to withhold 20~30 times, observe each part correctly before use. Lock in winter should be unloaded to withhold 20-30, so that the oil temperature increases. 2. press the opening button, open the mould. Depending on the crimping hose sizes selecting appropriate tooling die on, and adjust the ruler ticks. (See the technical data reference tables) 3. hose with connectors placed in the lock position, making a withholding of full length. 4. withholding button is pressed the Executive to withhold actions until the lock stop withheld so far. 5. press the opening button, remove the withholding of a hose assembly. Using a Vernier caliper testing after withholding tube od, as inconsistent with the parameter table should be fine tuning ruler ticks, and repeat, until you meet the requirements.

四、试例 扣压Φ19Ⅲ层胶管(按JB1885-77标准制造) 从锁管技术参数参考表中查得Φ19Ⅲ层胶管胶套外径扣压前为39mm,扣压后为35mm,应选用得模具内径为Φ34,对应标尺为3.5.将内径为Φ34模具置于模具内,并将标尺刻度旋至3.5处,将胶管剥皮后与接头组装好. 按 操作 中得步骤进行扣压操作,扣压完毕后测量管套外径,如测得尺寸为Φ35 mm,则完成扣压.如扣压直径不符,精调标尺后重新扣压,例:测得尺寸为Φ35.5mm,则逆时针调整标尺1.75圈即可.因胶管及管套的生产厂家不同,产品的具体尺寸、材质可能不尽相同,因此表中数据仅供参考,具体扣压尺寸应以压力实验为依据. Four rubber tubes test cases to withhold PHI

19 (manufactured according to JB1885-77 standards) from the tube technical parameters in the reference table is read-locked hose rubber sleeve outer diameter φ

19 39mm before withholding, withheld after the 35mm, should select the die diameter for PHI 34, ruler of 3.5. Inner diameter for PHI

34 mold placed in the mold, and ruler ticks spin to 3.5, rubber tube skinned assembl........