PDF《5000 series》

2 hex nuts

8 mm (.314) across flats,

1 locking ring and

1 lockwasher. Standard and special hardware available are presented in section I. Packaging unit :

25 pieces or

50 pieces depending on models. Finish Blank Nickel plated G Black finish on bushing, actuator and hardware. Fluorescent tip Blank None -038 White fluorescent tip to lever Available with matt black finish (G) only. Special options Blank No special requirement X408 Front panel sealing by two O-rings X404 Horizontal right angle with reduced overall dimensions Other : specific bushing height, PC terminal length, finish, ratings, etc... See following pages. Caps and paddles Caps Length U270

11 (.433) U1710 7,3 (.287) Paddles U240N 12,4 (.488) U290N

20 (.787) U390N 21,5 (.846) Contact materials A Silver AD Silver, gold plated CD Brass, gold plated For peak currents, see X814, under Special Options. Sealing Blank No sealing except where standard B Epoxy sealed terminals K Front panel sealing by one O-ring and sealing washer Sealing AAAby two O-rings, see X408 under Special options . Levers Length with threaded plain bushing bushing Blank (std) 10,5 (.413) 13,5 (.531) -2

16 (.629)

19 (.748) -7 - 6,6 (.259) -8 (flat) 21,3 (.838) - -9 (flat) 11,4 (.448) - -12 (flat) 6,3 (.248) - -16 5,5 (.216) 8,5 (.334) -17

7 (.275)

10 (.393) -21 (+ U640) 21,3 (.838) - insulated -22 21,3 (.838) - -23

14 (.551) - Blank (large) 17,5 (.688) - -25 16,30 (.642) -27 (large) 11,7 (.460) - -4N

9 (.354)

12 (.472) 4N for use with paddle actuators only. Approvals UL CSA CECC Availability : Consult factory for details of approved models. For VDE, refer to 55000. Locking levers -1V

1 locked position -2V

2 locked positions -3V

3 locked positions Other, consult factory. For models with ? 6,35 (1/4) bushing. 05-Serie 5000-A-structure_05-Serie 5000-A-structure 30/10/14 14:58 Page23 A-24 APEM www.apem.com A

5000 series Toggle switches Specifications MATERIALS ? Case : diallylphthalate (DAP) or high temperature plastic material (UL94-V0) ? Actuator : brass, nickel plated ? Paddles : UL94HB polyamide ? Lever caps : vinyl ? Bushing : brass, nickel plated ? Housing : stainless steel or steel tin plated ? Contacts A : silver AD : silver, gold plated CD : brass, gold plated X814 : for peak currrents, see Special options . ? Terminal seal : epoxy ELECTRICAL SPECIFICATIONS ? Current/voltage rating with resistive load : Contact Maximum Minimum Level* Silver (A) 4A 30VDC 50mA 10VDC III and IV Silver, 4A 30VDC 10mA 50mV I to IV gold plated (AD) Gold plating withstands up to 100mA 30VDC 10?A 5V Brass, 0,4 VA at 20VAC or DC 10mA 50mV I and II gold plated (CD) 10?A 5V ? For inductive, lamp or capacitive load, consult factory. * For details, see Technical Information, end of catalogue. ? Initial contact resistance :

10 m? max. ? Insulation resistance : 1.000 M? min. at 500VDC ? Dielectric strength : 1.000 Vrms

50 Hz min. between terminals 1.500 Vrms

50 Hz min. between poles 1.500 Vrms

50 Hz min. between terminals and frame ? Contact bounce :

2 ms max. ? Electrical life at full load : 50.000 cycles for single and double pole 40.000 cycles for

3 pole 30.000 cycles for

4 pole ? Low level or mechanical life : 100.000 cycles GENERAL SPECIFICATIONS ? Torque : 1,25 Nm (.922 Ft.lb) max. applied to nut ? Panel thickness : 2,5 mm (.098) with

2 nuts -

4 mm (.157) with

1 nut ? Operating temperature : -40°C to +85°C AGENCY APPROVA........