PDF《产品规格书》

376 400

416 W 灯电压 Lamp Voltage HPS/MH 400W

74 100

150 V 点火脉冲 Ignition Voltage Cload60℃,产品进入高温保护状态,关闭输出.当温度下降后重新上电,产品正常工作. When Ta>60℃,the ballast will shut off for high temperature protection. When the temperature drop to normal and the power is re-applied to the product, it can work normally. 2.3.4 灯泡寿命终结/整流效应/Lamp END of Life/Rectification 当灯泡寿命终结出现整流效应时产品不损坏 .更换灯泡重新上电产品正常工作. The ballast will be not when the rectification appears at the end of the lamp life. When replacing a new lamp and the power is re-applied, it can work normally. 2.3.5 高/低压保护 Over-voltage/ Low-voltage Detect Protection 当输入电压低于 100V 或高于 275V 时,产品关闭输出,进入保护状态(输入电压在 100-175V 产品 功率降至 50%运行).电压恢复正常,产品正常工作. Protection happens when input voltage is below 100V or up to 275V. (Output power will drop to 50% when input voltage is 100-175V).The ballast is closed .When input voltage is back to normal,the ballast can work normally. 备注:电压精度为 5%./Note: Voltage accuracy is 5%. 2.3.6 对地保护/Ground fault protection 当产品的任意输出线对地,产品进入保护状态,不被损坏,当排除故障后,重新上电,产品正常工作. If any output wire grounded, our product will go into protection status to avoid damage. After fault clearing, try to power-on again, product will work normally. 日期/Date 编制/Prepared 审核/Checked 项目号 Item No LT400EB16101 damaged 苏州市纽克斯照明有限公司 Lumlux Lighting Inc.

5 3. 环境/Environment 状态/Conditions 环境/Environment 工作 Operating 运输和储存 Shipping and Storage 3.1 温度/Temperature -20℃--+40℃ -40℃--+70℃ 3.2 湿度/Humidity 0%--90%, 无冷凝/non-condensing 0%--95%, 无冷凝/non-condensing 3.3 振动/Vibration 振幅/Amplitude:0.035mm 振幅/Amplitude:0.15mm 频率/Frequency:10-150Hz 任意方向的测试时间/Test time in any Direction:30min 扫描速度/Sweep velocity:1oct/min 方向/Direction:X,Y,Z 3.4 防尘防水等级 waterproof and dustproof IP20 4. 安规/Safety 4.1 表面温升/Surface Temperature Rise 产品输出 400W,环境温度为 25℃,输入电压为 220V 时,产品表面温升为 30℃. When output power is 400W,ambient temperature is 25℃and input voltage is 220Vac, the surface temperature rise will be 30℃. 4.2 泄漏电流/Leakage Current 1mAmax V mains=220V/50Hz. 4.3 绝缘电阻/Insulation Resistance 500Vdc 60S,产品的绝缘电阻不低于 2MΩ. The insulation resistance shall be no less than 2M ohm after application of 500Vdcfor 60s. 4.4 介电耐压强度(高压)/Dielectric Withstand Voltage (HI-POT) L,N-PE:1500Vac 5.5mAmax/60s. 4.5 接地电阻/Grounded Resistance