PDF《产品规格书》

1 min between adjacent terminal or ground. 外观:无击穿和飞弧现象 Appearance: No Breakdown 5.3 环境性能 Environmental 序号 No. 项目Item 测试条件 Test Condition 规格Requirement 5.3.1 可焊性 Solderability 焊接部涂上助焊剂后,100~110℃预热

30 秒,把试验样品需要焊接的部位浸入焊锡炉 中,锡炉温度(250±2)℃;

时间(2-3)s Soldering Time: (2-3)s Solder Temperature: (250±2)℃ 上锡率≥80%: 80% of immersed area must show no voids, pin holes 5.3.2 耐焊接热 Resistance to Soldering Heat 连接器配对后,将需要焊接的部位浸入焊锡 炉中,锡炉温度(260±5)℃;

时间(10±1) s 后,在正常条件下恢复 1h 后测量插针固定 力Soldering Time: (10±1)s Solder Temperature: (260±5)℃ 外观:无损伤 Appearance: No Damage 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 端子固定力:10N Min 5.3.3 耐高温 Heat Resistance 连接器配合后,于105±2℃的空气中放置

168 小时,再回到室温中放置 0.5 小时测定 Mated connectors are exposed to a temperature of 105±2℃ for

168 hours. And then exposed to the room temperature for 0.5h. 外观:无损伤 Appearance: No Damage 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 绝缘电阻:50MΩ Min Insulation Resistance: 50MΩ Min 耐电压:500V,AC/minute 产品规格书 Product Specification 编号Serial number PS3787 版本号Version Number

1 产品名称 Product Name TJC20055-13A WT / CZ-TJC20055 产品编码 Part Number / Page

9 of

9 5.3.4 耐低温 Cold Resistance 连接器配合后,于-40±2℃的空气中放置

1000 小时后测定绝缘电阻,0.5 小时后测定 接触电阻、耐电压、绝缘电阻. Mated connectors are exposed to a temperature of -40±2℃ for

1000 hours. Then And then exposed to the room temperature for 0.5h. 外观:无损伤 Appearance: No Damage 绝缘电阻:1MΩ Min Insulation Resistance: 1MΩ Min 0.5 小时后: 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 绝缘电阻:50MΩ Min Insulation Resistance: 50MΩ Min 耐电压:500V,AC/minute 5.3.5 恒定湿热 Humidity 温度(40±2)℃, 相对湿度(90~95)% 搁置时间 1000h,取出测定绝缘电阻,30 分 钟后测定接触电阻、耐电压、绝缘电阻. Temperature: (40±2)℃ Relative Humidity: (90~95)% Duration:

1000 h 外观:无损伤 Appearance: No Damage 绝缘电阻:1MΩ Min Insulation Resistance: 1MΩ Min 0.5 小时后: 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 绝缘电阻:50MΩ Min Insulation Resistance: 50MΩ Min 耐电压:500V,AC/minute 5.3.6 温升 Temperature Rise 插合连接器,通以 1.5A 电流 Carrying rated current loading. 20℃ Max 5.3.7 盐雾 Salt Spray 把试验样品从试验箱顶悬挂下来,采用浓度 为(5±1)%(质量百分比)的氯化钠溶液: A)连续雾化 8h B)在常温常湿条件下恢复 16h 从A)到B)为一个循环周期, 共进行

3 个循环 试验后用流动的蒸溜水轻轻洗去表面沉积 物. 外观:无损伤 Appearance: No Damage 接触电阻:0.02Ω Max LLCR: 0.02Ω Max 5.3.8 机械振动 插合连接器,串联在一直流电源上,电流 100mA;

并模拟正常工作状态,振频为(10~ 55)Hz、振幅 1.5mm;

加速度 50m/s2.每一 轴线扫频循环次数 2h. Frequency: (10~55)Hz, Amplitude:±1.5mm;

Acceleration: 50m/s2;

Duration: 2h in each X,Y,Z axe 外观:无损伤 Appearance: No Damage 中断: 1μsec Max. Intermittence: 1μsec Max. 接触电阻:0.02Ω Max LLCR: 0.02Ω Max