PDF《FJ-35》

100 or higher, or incinerate the Controller. Since camera that can be connected with this product emits a visible light that may have an adverse affect on the eyes, do not stare directly into the light emitted from the LED. If a specular object is used, take care not to allow reflected light enter your eyes. Danger of burns. Do not touch the case while the LED is ON or just after power is turned OFF, since it remains extremely hot. ? Use a DC power supply with safety measures against high-voltage spikes(safety extra low-voltage circuits on the secondary side). ? Do the following confirmations again before turning on the power supply. - Is the voltage of the power supply correct? (24VDC) - Is not the load of the output signal short-circuited? - Is the load current of the output signal appropriate? - Is not the mistake found in wiring? ? ? ? It is short-circuited with FG of the customer device when installing it directly because the case of the controller is connected with SG(0V). ? Do not ground the 24VDC power supply'

s positive terminal. If the positive terminal is grounded, it causes the electric shock when you touch the SG(0V) such as case of the controller or the camera. Other ? Use only the camera and cables designed specifically for the product. Failure to observe this result in malfunction or damage of the product. ? Always turn OFF the Controller'

s power before connecting or disconnecting a camera or cable. ? Do not attempt to dismantle,repair,or modify the product. ? Should you notice any abnormalities,immediately stop use,turn OFF the power supply,and contact your OMRON representative. ? Do not touch fluorescent or halogen lights while the power is ON or immediately after the power is turned OFF. ? Dispose of this product as industrial waste. Regulations and Standards The Controller complies with the following standards. EN Standards(European Standards), EN61326-1 (Electromagnetic environment : Industrial electromagnetic environment (EN/IEC 61326-1 Table 2) Also, the following condition is applied to the immunity test of this product. : If the level of disturbance of the video is that with characters on the monitor are readable, the test is pass. Regulation of KC marking A? ?? (??? ???????) ? ??? ???(A?) ????????? ??? ?? ???? ? ?? ????? ???,???? ???? ???? ?? ???? ???. ? Keep the power supply wires as short as possible (Max.10m). Installation and Storage Sites Install and store the product in a location that meets the following conditions: ? Surrounding temperature of

0 to

50 (-20 to +65 in storage) ? No rapid changes in temperature (place where dew does not form) ? Relative humidity of between

35 to

85 % ? No presence of corrosive or flammable gases ? Place free of dust, salts and iron particles ? Place free of vibration and shock ? Place out of direct sunlight ? Place where it will not come into contact with water, oils or chemicals Orientation of Product To improve heat dissipation, install the product in the following orientation only. Ambient Temperature ? Maintain a minimum clearance of

50 mm above the controller to improve air circulation. A minimum clearance of

25 mm between other devices must also be maintained on the right, left and back sidesof product. ? Do not install the product immediately above significant heat sources, such as heaters, transformers, or large-capacity resistors. ? Do not let the ambient temperature exceed

50 (122°F). ? Provide a forced-air fan cooling or air conditioning if the ambient temperature is near

50 (122°F) so that the ambient temperature never exceeds