PDF《产品规格书》

2 PAGE:

4 /

8 5.参数范围 Parameter Ratings: 6. 产品性能 Performance 6.1 机械性能 Mechanical 序号 No. 项目Item 测试条件 Test Condition 规格Requirement 6.1.1 外观 Appearance 目测 Checking by eye 视力:1.0 以上 Eyesight: > 1.0 照明: (200~300)lx Lamp: (200~300)lx 目测距离: (0.3~0.5)m Space: (0.3~0.5)m GB/T 5095.1 Method 1a 1.塑料件表面应无明显疤痕、凹陷、开裂及影响使用的变形. Plastic part: smooth and flat surface without discolor, broken, crack, and distortion, etc.

2 金属件表面无锈蚀、 氧化 、 无明显的机械损伤及电镀层脱落 等缺陷. Metal part: bright and even surface without rust, oxide, fog and obvious physical damage, etc. 6.1.2 成品插入力与拔 出力 Insertion and Withdrawal Force for Connector 固定连接器和/或测力计,在连接器轴线方向插入和 拔出;

速度(25± 3)mm/min Apply axial Insert and withdraw force on the terminal in the housing at a rate of

25 ±3 mm per minute. GB/T 5095.7 Method 13b / EIA-364-13B PIN NO. First At 50th Insertion (Max) withdrawal (Min) withdrawal (Min)

2 29.4N 7.8N 5.9N

3 34.3N 9.8N 7.8N

4 39.2N 11.8N 8.8N

5 44.1N 11.8N 8.8N

6 49.0N 13.7N 9.8N

7 53.9N 13.7N 9.8N

8 58.8N 15.7N 11.8N

9 63.7N 15.7N 11.8N

10 68.6N 17.6N 13.7N

11 73.5N 17.6N 13.7N

12 78.4N 19.6N 15.7N 额定电流 Rated Current AWG28 AWG26 AWG24 AWG22 1.5A 2A 2.5A 3A 适用 PCB 板Applicable P.C.B Board Thickness:1.6mm Hole Diameter:0.9mm-1.0mm 额定电压 Rated Voltage 250V [AC(有效值 rms)/DC] 使用温度范围 Operating temperature range -25℃~+85℃ 适用线型 Applicable wires Wire Size:AWG28~AWG22(0.08mm? -0.326 mm? ) Insulation Diameter:1.15mm-1.8mm 产品规格书 PRODUCT SPECIFICATION 产品名称 Product Name: TJC25048 系列条形连 接器 编号 Document No. PS3868 版本号 VersionNo.

2 PAGE:

5 /

8 6.1.3 端子的插入力和 固定力 Insertion Force and Retention Force for Contact 固定连接器和/或测力计,在连接器轴线方向插入和 拔出;

速度(25± 3)mm/min Apply axial withdraw force on the terminal in the housing at a rate of

25 ±3 mm per minute. GB/T 5095.8 Method 15d / EIA-364-29B 插入力 (Insertion) Max. 固定力(Retention) Min. 10N 19.6N Min 6.1.4 压着部位抗张强 度Crimping Pull Out Force 在试验装置夹头中固定试验样品, 在连接的轴线方向 施加张力;

速度不大于 25mm/min Fix the crimped terminal, Axial pull out force on the terminal in the housing at a rate less than

25 mm per minute. GB/T5095.8 Method 16d / EIA-364-08B AWG 28: 10N Min. AWG 26: 20N Min. AWG 24: 30N Min. AWG 22: 40N Min 6.1.5 机械振动 Random Vibration 插合连接器,串联在一直流电源上,电流 100mA;

并模 拟正常工作状态;

振频为(10~55~10)Hz,每个循 环时间为

1 分钟,振幅 1.52mm.沿XYZ 三轴正反方 向各循环 2h. Mated connectors subjected to following vibration conditions, for a period of

2 hours in each of

3 mutually perpendicular axes,

100 mA current shall be applied. Frequency: (10~55~10)HZ/min. Amplitude: 1.52mm GB/T 5095.4 Method 6d / EIA-364-28D 外观:无损伤(参照 6.1.1) Appearance: No damage.( refer to 6.1.1) 接触电阻:0.02Ω Max. Contact resistance: 0.02Ω Max. 中断: 1μsec Max.