PDF《产品规格书》

8 of

10 产品规格书 Product Specification 编号Serial number PS1342 版本号Version Number

2 产品名称 Product Name TJC2511 直式条形连接器 产品编码 Part Number

9 可焊性 Solderability 把试验样品需要焊接的部位浸入焊锡炉中,锡炉温度 (245±5)℃,时间(4~5)s Dip solder tails into the molten solder held at (245±5) ℃for ((4~5) sec. EIA-364-52 上锡率≥95%: Solder coverage: ≥95%

10 耐焊接热 Resistance to Soldering Heat 耐波峰焊热:把试验样品需要焊接的部位浸入焊锡炉 中,锡炉温度(260±5)℃;

时间(5±1)s 后,在正 常 条件下恢复1~2h. 手工焊接:温度(350±10)℃,时间(3±0.5) seconds Resistance to Wave Soldering Heat :Dip solder tails into the molten solder held at (260 5) ℃ for (5 ±1) sec., Recovery time 1~2 hours Manual soldering :(350±10)℃for(3±0.5) seconds 外观:无损伤(参照6.1.1) Appearance: No damage.( refer to 6.1.1)

11 耐高温 Heat Resistance 连接器配合后,于85±2℃的空气中放置

96 小时,再 回到室温中放置 1-2 小时测定 Mated connectors are exposed to a temperature of 85± 2℃ for

96 hours. 外观:无损伤(参照6.1.1) Appearance: No damage.( refer to 6.1.1) 接触电阻:0.02Ω Max. Contact resistance: 0.02Ω Max. 绝缘电阻:500MΩ Min Insulation Resistance: 500MΩ Min 耐电压:1000V Min. Withstand Voltage: 1000V Min.

12 耐低温 Cold Resistance 连接器配合后,于-25±2℃的空气中放置

96 小时, 再 回到室温中放置 1-2 小时测定 Mated connectors are exposed to a temperature of -25± 2℃ for

96 hours. 外观:无损伤(参照6.1.1) Appearance: No damage.( refer to 6.1.1) 接触电阻:0.02Ω Max. Contact resistance: 0.02Ω Max. 制订Edit 吴吉 2019.1.10 审核Check 王曲 2019.1.12 批准Approval 刘冬旭 2019.1.13 Page

9 of

10 产品规格书 Product Specification 编号Serial number PS1342 版本号Version Number

2 产品名称 Product Name TJC2511 直式条形连接器 产品编码 Part Number

13 温度循环 Temperature Cycling 把试验样品分别放入高、低温试验箱中,按下列步骤 调试温度: a) 在(-25±2)℃的恒温条件下放置 0.5h;

b) 在(85±2)℃的恒温条件下放置 0.5h;

从a)到b)为一个循环,周期温度转换时间应不大于

5 分钟,共进行

25 个循环,恢复 1~2h 后检查. Mated connectors shall be tested under the following conditions Temperature °C Duration (Minutes)

1 -25

30 2 +25 5Max.

3 +85

30 4 +25 5Max. Step

1 to

4 is one cycle,25 cycles shall be tested. Recovery time 1~2 hours. GB/T 5095.6 method 11d / EIA-364-32C 外观:无损伤(参照6.1.1) Appearance: No damage.( refer to 6.1.1) 接触电阻:0.02Ω Max. Contact resistance: 0.02Ω Max. 绝缘电阻:500MΩ Min Insulation Resistance: 500MΩ Min 耐电压:1000V Min. Withstand Voltage: 1000V Min.

14 恒定湿热 Humidity 温度 40±2℃, 相对湿度(90~95)% 搁置时间 240h,取出恢复 1~2h 后检查. Mated connectors exposed to the condition of temperature 40±2 ℃ , humidity (90~95)% for

240 hours. Recovery time 1~2 hours GB/T 5095.6 Method 11c /EIA-364-31B 外观:无损伤(参照6.1.1) Appearance: No damage.( refer to 6.1.1) 接触电阻:0.02Ω Max. Contact resistance: 0.02Ω Max. 绝缘电阻:500 MΩ Min. Insulation Resistance :500 MΩ Min. 耐电压:1000V Min. Withstand Voltage: 1000V Min.

15 温度上升 Temperature Rise 插合连接器,通以最大允许电流,测温度的差值 Mate connectors and measure the temperature rise of contact when the maximum AC rated current is passed. GB/T 5095.3 Method 5a / EIA-364-70A 60℃ Max.