PDF《产品规格书》

6 PAGE:

4 /

9 5.参数范围 Parameter Ratings: 6.产品性能 Performance 6.1 机械性能 Mechanical 序号 No. 项目Item 测试条件 Test Condition 规格Requirement 6.1.1 外观 Appearance 目测 Checking by eye 视力:1.0 以上 Eyesight: >

1.0 照明: (200~300)lx Lamp: (200~300)lx 目测距离: (0.3~0.5)m Space: (0.3~0.5)m GB/T 5095.1 Method 1a 1.塑料件表面应无明显疤痕、凹陷、开裂及影响使用的变形. Plastic part: smooth and flat surface without discolor, broken, crack, and distortion, etc.

2 金属件表面无锈蚀、氧化 、无明显的机械损伤及电镀层脱 落等缺陷. Metal part: bright and even surface without rust, oxide, fog and obvious physical damage, etc. 6.1.2 端子的插入力 与固定力 Insertion force and Retention Force for Contact 固定连接器和/或测力计,在连接器轴线方向插入和拔出;

速度不大于

25 mm/min. Axial Insert and withdraw force on the contact in the housing at a rate less than

25 mm/min. GB/T 5095.8 Method 15d / EIA-364-29B 插入力 (Insertion) Max. 固定力(Retention) Min. 9.8N 29.4N 额定电流 Rated Current 3A 额定电压 Rated Voltage 250V [AC(有效值 rms)/DC] 使用温度范围 Operating temperature range -25℃~+85℃ 适配基板厚度 Applicable PC board thickness 1.2~1.6mm 适用线型 Applicable wires Wire Size:TJC3 AWG24#~AWG22#(0.2mm?-0.32 mm?) TJC3-1 AWG26#(0.12 mm?) Insulation Diameter: TJC3 AWG24#~AWG22#(0.2mm?-0.32 mm?) TJC3-1 AWG26#(0.12 mm?) 产品规格书 PRODUCT SPECIFICATION 产品名称 Product Name: TJC25020 编号 Document No. PS2657 版本号 VersionNo.

6 PAGE:

5 /

9 6.1.3 针的固定力 Retention Force for Pin 固定连接器/或测力计,在连接器轴线方向施加规定的推 力进行测试, 速度不大于 25mm/min. Apply thrust force on the Pin in the wafer at a rate of

25 mm/min . GB/T 5095.8 Method 15a / EIA-364-29B 15N Min 6.1.4 压着部位抗张 强度 Crimping Pull Out Force 在试验装置夹头中固定试验样品, 在连接的轴线方向施加 张力;

速度不大于 25mm/min. Fix the crimped contact, Axial pull out force on the contact in the housing at a rate less than

25 mm/min. GB/T5095.8 Method 16d / EIA-364-08B AWG 28: 10N Min. AWG 26: 20N Min. AWG 24: 30N Min. AWG 22: 40N Min. 6.1.5 成品插入力与 拔出力 Insertion and Withdrawal Force for Connec........