PDF《PICO-GUARD》

Printed in USA 04/04 P/N

69761 rev.

B

9714 10th Avenue North ? Minneapolis, MN

55441 Phone: 763.544.3164 ? http://www.bannerengineering.com Email: [email protected] Controller Instruction Manual Models SFCDT-4A1, SFCDT-4A1C Section Contents Section

1 System Overview Page

1 Section

2 System Components and Specifications Page

3 Section

3 Installation and Alignment Page

6 Section

4 System Operation Page

18 Section

5 Troubleshooting and Maintenance Page

28 Section

6 Periodic Checkout Procedures Page

32 PICO-GUARD? Fiber Optic Safety System Patent Pending Banner Engineering Corp. ? Minneapolis, MN U.S.A. www.bannerengineering.com ? Tel: 763.544.3164 PICO-GUARD Controller Instruction Manual Important ... read this page before proceeding! In the United States, the functions that PICO-GUARD Systems are intended to perform are regulated by the Occupational Safety and Health Administration (OSHA). Outside of the United States, these functions are regulated by a variety of agencies, organizations, and governments. Whether or not any particular PICO-GUARD System installation meets all applicable requirements depends upon factors that are beyond the control of Banner Engineering Corp. These factors include the details of how the PICO-GUARD System is applied, installed, wired, operated, and maintained. It is the responsibility of the purchaser and user to apply this PICO-GUARD System in full compliance with all relevant applicable regulations and standards. PICO-GUARD Systems can guard against accidents only when they are properly installed and integrated into the machine, properly operated, and properly maintained. Banner Engineering Corp. has attempted to provide complete application, installation, operation, and maintenance instructions. In addition, we suggest that any questions regarding application or use of PICO-GUARD Systems be directed to the factory applications department at the telephone number or addresses shown on the back cover. In addition to OSHA regulations, several other organizations provide information about the use of safeguarding devices. Refer to the American National Standards Institute (ANSI), the Robotics Industries Association (RIA), the Association for Manufacturing Technology (AMT), and others. Banner Engineering Corp. makes no claim regarding a specific recommendation of any organization, the accuracy or effectiveness of any information provided, or the appropriateness of the provided information for a specific application. The user has the responsibility to ensure that all local, state, and national laws, rules, codes, and regulations relating to the use of this safeguarding system in any particular application are satisfied. Extreme care is urged to ensure that all legal requirements have been met and that all installation and maintenance instructions contained in this manual are followed. Table of Contents 1. System Overview page

1 1.1 Description.1 1.2 Applications and Limitations

2 2. System Components and Specifications Page

3 2.1 Controller

3 2.2 Plastic Optical Fiber

3 2.3 Accessories

4 2.4 Replacement Parts

4 2.5 Literature

4 2.6 Dimensions

4 2.7 Specifications.5 3. Installation and Alignment.Page

7 3.1 Excess Gain

7 3.2 Security Protocol

8 3.3 Controller Installation.8 3.4 Electrical Connections

9 3.5 Optical Fiber Installation.9 3.6 Optical Element Installation

10 3.7 External Stop Device Installation

10 3.8 Initial System Checkout

11 3.9 Electrical Interface to Guarded Machine (Permanent Hookup)12 3.10 Preparing for System Operation