PDF《INSULATED CONDUCTOR SYSTEMS》

100 m are expansion sections required (see installation instructions). Feed terminals The feed will be installed between two conductor rails instead of a standard joint. To connect this feed please consider single core cables. End caps The end caps are the touch proof end of the conductor rails. Entry funnel and transfer guides For the use in spurlines, turntables and switches are transfer gui- des and entry funnels available. Isolating sections Isolating sections are electrical interrupts of the conductor. Under normal operating conditions a cross over with collectors to switch the voltage off or on is only allowed with low power ratings (control current). For control reasons, feed tracks, repair areas etc. we supply isolating sections. Curves The insulated conductor rails could be bend in horizontal or vertical curves. The rails are depending on type and radius bend in our factory or on site. Current collectors Depend on usage single or double collectors are used. The mentioned contiuous currents are for collectors in standard use with conudoctor profiles with copper surface. With the AE-conductor rail the collectors of consumers which remain at one place continously or work under a very low travel speed (e.g. 10/min.) the maximum continous current is approx. 50% of the mentioned continous current. The length of the cable should not extend

3 m if the fuse is not laid out for this load capacity. (See aswell DIN VDE 0100, part

430 and DIN EN 60204) Note: The a.m. Often occurs in systems with more than one collector) The supplied connecting cables (H07RN-F) are for the mentioned nominal currents big enough. For the different cable layouts have the reduction factors of DIN VDE

0298 to be considered. Safety advice It must be ensured that the arrangement of the conductor system provides minimum distances (0,5 m) between fixed and mobile parts. (i.e. Between conductor rails, collector trolleys and towing arms) so as to avoid the risk of pinching. Chemical resistance for both designs: Shroudings in the standard design (color green) and in the heat resistant design (color grey) are resistance against mineral oil, fats, caustic soda 25%, caustic soda 50%, concentrated hydro- chloric acid;

suflfuric acid upto 50%. Please note: For use in galvanizing and pickling plants, under agressive conditions and low voltage applications we would appreciate receiving detailled information,espe- cially of the environmental conditions. For quotations and order processing including Powerail systems with curves, dead sections, turntables, switches etc. we require your drawings or sketches. Insulating covers Standard shrouding colour green High temp. shrouding colour grey Electrical properties: dielectric strength DIN

53 481 specific resistance DIN

53 482 Surface resistance according to IEC

60093 Creep resistance according to IEC 60112/ VDE

0303 Mechanical properties: flexible strength tensile strength Temperature resistance flame test proof per DIN

4102 part

1 30-40 kV/mm

5 x

1015 Ohm/cm

1013 Ohm

5 x

1017 Ohm/cm

1015 Ohm

45 kV/mm CTI>

600-2,7

75 N/mm2 ± 10%

50 N/mm2 ± 10% C30 °C thru +55 °C class B........