PDF《INVERTER FR-E700-SC(-EC)(-NA)/NF/NC》

s User Manual for discharging time). Standards Mitsubishi FR-E700-SC/NF/NC safety stop function meets the following directives and categories. ISO13849-1:2008 Category 3/PLd IEC62061:2005 / IEC61800-5-2:2007 / IEC61508 SIL2 IEC60204-1:2006 / IEC61800-5-2:2007 Stop category

0 WARNING The misuse of safety function leads to personal injury or death, property damage, or economic loss. To ensure that the system complies fully with requirement of safety, make a system-level risk assessment. Mitsubishi Electric Co. cannot assume responsibility for any system to comply with safety directive.

3 2.Installation and wiring CAUTION The following information is merely a guide for proper installation. Mitsubishi Electric Co. cannot assume responsibility for the compliance or the noncompliance to any code, national, local or otherwise for the proper installation of this equipment. A hazard of personal injury and/or equipment damage exists if codes are ignored during installation. CAUTION Ensure the safety relay unit and the FR-E700-SC/NF/NC unit is mounted closely in enclosure meeting IP54 and all interconnection wiring is short and protected against open and short circuit faults. Refer ISO/IEC13849-2. Installation Mitsubishi FR-E700-SC/NF/NC safety stop function should be used under following condition and environment. Table.1 The condition and environment for using safety stop function Item Condition Temperature range Operation -10?C to +50?C (non-freezing) Storage -20?C to +65?C Ambient humidity 90%RH maximum (non-condensing) Vibration 5.9m/s

2 or less Altitude maximum 1000m above sea level Atmosphere Indoors (without corrosive gas, flammable gas, oil mist, dust and dirt etc.) Over voltage category II or less Pollution degree II or less Mounting wall mounting / vertical orientation CAUTION In order to meet safety stop, an approved safety relay unit to ISO13849-1/EN954-1 safety category

3 or better shall be used in conjunction with FR-E700-SC/NF/NC as shown in example. In addition, all other components with in the safety stop loop shall be '

safety approved'

types. WARNING To avoid an electric shock hazard, insert the magnetic contactor (MC) between power source and drive. Open the contact of MC and keep away from drive for discharging time (refer to your drive'

s User Manual for information) before performing any work on the drive. And verify that the voltage on the bus capacitors has discharged before Measure the DC bus vo........