PDF《产品规格书》

6 9A 8A 6A 4A 3A 2A 4.3 使用温度范围Operating Temperature Range -40℃~+105℃ 4.4 产品符合合兴企标Q/HX J1150001《产品零部件和材料中有害物质的规定》I类或顾客要求. The connector should comply with CWB standard Q/HX J1150001 Class I or customer'

s requests.

5 产品性能 Performance 5.1 机械性能 Mechanical 序号 No. 项目Item 测试条件 Test Condition 规格Requirement 5.1.1 外观 Appearance 目测 Checking by eye 视力:1.0 以上 Eyesight: >

1.0 照明: (200~300)lx Lamp: (200~300)lx 目测距离: (0.3~0.5)m Space: (0.3~0.5)m

1 塑料件表面应无明显疤痕、凹陷、开裂及影响 使用的变形 Plastic part: smooth and flat surface without discolor, broken, crack, and distortion, etc.

2 金属件表面无锈蚀、氧化 、无明显的机械损 伤等缺陷 Metal part: bright and even surface without rust, oxide, fog and obvious physical damage, etc. 5.1.2 插拔力 Insertion / Withdrawal force 去除锁扣,连接器相配,以25±3mm/minute的速度 沿接插器轴线方向插入和拔出. Insertion and withdraw connectors at the speed rate of 25±3mm/minute without Lock. 第6项参照 Refer to paragraph

6 Page

6 of

8 产品规格书 Product Specification 编号Serial number PS3347 版本号Version Number

2 产品名称 Product Name TJC65002-nAD 阳连接器 产品编码 Part Number 见附表 5.1.3 机械寿命 Durability 以每分钟

10 次的速度插拔

30 次. When mated up to 30cycles repeatedly by the speed rate of

10 cycles per minute. 外观:无损伤 Appearance: No damage. 接触电阻 LLCR:0.02Ω Max. 5.1.4 机械振动 Vibration 插合连接器, 串联在一直流电源上,电流 1mA;

并模拟 正常工作状态,振频为(10~500)Hz、振幅 0.35mm. 每一轴线扫频循环 2h. Frequency: (10~500)Hz Amplitude: 0.35mm Duration: 2h in each X,Y,Z axe 外观:无损伤 Appearance: No damage 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 中断: 1μsec Max. Intermittence: 1μsec Max. 5.1.5 机械冲击 Shock 连接器相配,沿XYZ 三轴正反方向各冲击

3 次(总共18 次),在测试过程中通以 1mA 电流. 冲击强度:490m/s^2 持续时间:11ms Mated connectors and subject to the following shock conditions, 3times of shock shall be applied for each

6 directions along

3 mutually perpendicular axes, passing DC 1mA current during the test.(Total of

18 shocks) Test Pulse: Half Sine Peak Value: 490m/s^2 Duration: 11ms 外观:无损伤 Appearance: No damage 接触电阻:0.02Ω Max. LLCR: 0.02Ω Max. 中断: 1μsec Max. Intermittence: 1μsec Max. 5.1.6 针的固定力 Pin Retention Force 固定连接器和/或测力计,以每分 25±3mm 的速度 沿连接器轴线方向将针拉出. Apply axial pull out force on the Plug Pin assembled in the housing at the speed rate of 25±3mm/minute. 20N Min. 5.2 电气性能 Electrical 序号 No. 项目Item 测试条件 Test Condition 规格 Requirement 5.2.1 接触电阻 Low Level Contact Resistance 插配阴阳连接器后,用小功率电路进行测试. Mate connectors and measure by dry circuit. 0.01Ω Max. Page

7 of

8 产品规格书 Product Specification 编号Serial number PS3347 版本号Version Number

2 产品名称 Product Name TJC65002-nAD 阳连接器 产品编码 Part Number 见附表 5.2.2 绝缘电阻 Insulation Resistance 在相邻接触件之间或地线之间,用500V DC 电压进 行测试. Apply 500V DC between adjace0nt terminal or ground. 1000MΩ Min. 5.2.3 耐电压 Dielectric Strength 相邻接触件之间或地线之间施加 50Hz 1500V AC (有效值),漏电流 1mA 的电压作用,时间 1min.. Mate connectors and apply 1500V AC for