编辑: 学冬欧巴么么哒 | 2016-05-10 |
4500 与Imaging Source 公司 Firewire 相机的连接示例 ZHCA617A www.ti.com DLP LightCrafter
4500 and The Imaging Source Firewire Camera Figure 7. DLP LightCrafter
4500 Control Software C Pattern Sequence/Sequence Settings Tab An example of setting DLP LightCrafter
4500 to trigger a camera on a Pattern Sequence is shown in Figure 7. Note that under Operating Mode the Pattern Sequence button has been selected . This automatically opens the Pattern Sequence/Sequence Settings tab. For this illustration, a pattern sequence has been created and sent to DLP LightCrafter 4500. Under Individual Pattern Settings the trigger has been set to Internal Trigger. The Internal Trigger (?s) has been set to
33333 ?s, which sets the period between successive patterns. This period results in a pattern rate of
30 frames per second. Important Note: The Pattern Exposure(?s) must be set shorter than the Internal Trigger (?s) by more than
230 ?s. If this requirement is not met, the pattern will not run. The control software will indicate an error by lighting the annunciator next to the Period Exposure diff <
230 in the Data Validation area. The trigger out signal corresponds in time to the Pattern Exposure (?s). That is, the trigger out signal will be active for the length of the exposure within the trigger period.
7 DLPA036ACJuly 2013CRevised June
2014 Using DLP? LightCrafter?
4500 Triggers to Synchronize Cameras to Patterns Submit Documentation Feedback Copyright ? 2013C2014, Texas Instruments Incorporated DLP LightCrafter
4500 和Imaging Source Firewire 相机 www.ti.com.cn 图7:DLP LightCrafter
4500 控制软件 - 模式序列 / 序列设置标签 图7示出了设定DLP LightCrafter 4500以在模式序列上触发一部相机的实例.请注意,在 操作模式 (Operating Mode) 下........