PDF《FLV-XC LN》

Dimensions INSTRUCTION SHEET Thank you for selecting OMRON product.

This sheet primarily describes precautions required in installing and operating the product. Before operating the product, read the sheet thoroughly to acquire sufficient knowledge of the product. For your convenience, keep the sheet at your disposal. ? OMRON Corporation

2013 All Rights Reserved. Model FLV-XC LN Extension Cable for Line Lighting (Unit:mm) PRECAUTIONS ON SAFETY Meanings of Signal Words Alert Statements in This Sheet This product is not designed or rated for ensuring safety of persons either directly or indirectly. Do not use it for such purposes. Indicates a potentially hazardous situation which, if not avoided, will result in minor or moderate injury, or may result in serious injury or death. Additionally, there may be significant property damage. WARNING Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or in property damage. CAUTION WARNING Do not use it exceeding the rated voltage. There is a possibility of failure and fire. CAUTION Speci?cations ? OMRON Corporation

2013 All Rights Reserved. FLV-XC LN Please observe the following precautions for safe use of the products. 1.Do not use the product in environments where it can be exposed to inflammable/explosive gas. 2.Do not attempt to disassemble, deform by pressure, incinerate, repair, or modify this product. 3.Ensure that all components are locked before using the product. 4.High-Voltage lines and power lines must be wired separately from this product. Wiring them together or placing them in the same duct may cause induction, resulting in malfunction or damage. 5.Before connecting/disconnecting the connectors, make sure that the Controller is turned OFF. The Conversion cable may break down if it is connected or disconnected while the power is ON. 6.When disposing of the product, treat as industrial waste. 7.Do not use in safety circuits for atomic energy or that are critical for human life. 8.If you notice an abnormal condition, immediately stop using the product, turn off the power, and consult your dealer. PRECAUTIONS FOR SAFE USE Observe the following to prevent failure, malfunctioning, and adverse effects on performance and the device. 1.Be sure to observe the specifications and ratings when using the Conversion cable. 2.Do not fasten the Conversion cable with stress applied to the connectors. 3.Never use paint thinner, benzine, acetone, or kerosene to clean the product. 4.Only one extension cable can be used. PRECAUTIONS FOR CORRECT USE 2279131-6B Align the groove of the cable with the protrusion of the connector, and then push and rotate the screw clockwise. Rotate the screw counterclockwise and pull the cable out of the connector. Do not pull out with excessive force without pressing the tab. Doing so may break the wire. Suitability for Use r Omron Companies shall not be responsible for conformity with any standards, codes or regulations which apply to the combination of the Product in the Buyer'

s application or use of the Product. At Buyer'

s request, Omron will provide applicable third party certification documents identifying ratings and limitations of use which apply to the Product. This information by itself is not sufficient for a complete determination of the suitability of the Product in combination with the end product, machine, system, or other application or use. Buyer shall be solely responsible for determining appropriateness of the particular Product with respect to Buyer'

s application, product or system. Buyer shall take application responsibility in all cases. NEVER USE THE PRODUCT FOR AN APPLICATION INVOLVING SERIOUS RISK TO LIFE OR PROPERTY WITHOUT ENSURING THAT THE SYSTEM AS A WHOLE HAS BEEN DESIGNED TO ADDRESS THE RISKS, AND THAT THE OMRON PRODUCT(S) IS PROPERLY RATED AND INSTALLED FOR THE INTENDED USE WITHIN THE OVERALL EQUIPMENT OR SYSTEM. See also Product catalog for Warranty and Limitation of Liability. Sep,