PDF《FD 10VB • FD 10SB》

4 English SPECIFICATIONS Model FD10VB FD10SB Voltage (by areas)* (110 V,

115 V,

120 V,

127 V,

220 V,

230 V,

240 V) Power Input

420 W* No-load speed

0 C

2800 /min

2800 /min Capacity Steel

10 mm Wood

25 mm Weight (without cord) 1.4 kg * Be sure to check the nameplate on product as it is subject to change by areas. APPLICATIONS 1. Drilling various materials Drilling metal Use a metal-working drill bit Drilling wood Use a wood-working drill bit (However, a metal-working drill bit to make pilot holes for wood screws or holes smaller than 6.5 mm.) 2. Tightening the wood screw (Only FD10VB model) Use the driver bit. Use a Phillips screw for easy tightening. PRIOR TO OPERATION 1. Power source Ensure that the power source to be utilized conforms to the power requirements speci?ed on the product nameplate. 2. Power switch Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, inviting serious accident. 3. Extension cord When the work area is removed from the power source, use an extension cord of su?cient thickness and rated capacity. The extension cord should be kept as short as practicable. 4. Check the tightening of the drill chuck The drill chuck has been tightened at the factory, but check again that it is in order before use. Turn the drill chuck clockwise to tighten. HOW TO USE 1. Operation of switch Pulling the trigger of switch and push the stopper, it keeps, the switched-on condition and it is convenient for the continuous running. When switched o?, the stopper can be disconnected by means of pulling the trigger again. 2. Adjustment of speed [FD10SB] The maximum speed can be obtained by pulling the trigger switch. [FD10VB] (1) The speed is adjustable from zero to maximum speed according to the extent the trigger switch is pulled. (2) The maximum speed is adjustable from zero to 2800/min with the rotation of adjusting knob. (3) Turn the adjusting knob clockwise for higher speed and counterclockwise for lower speed. (Rotate the adjusting knob approximately 1-2/3 turns.) (Fig. 1) (4) The switch can be locked with the stopper at any required position irrespective as to how far the adjusting knob has been rotated. Select a proper position according to the required speed for each work. 3. Con?rm the direction of bit rotation (Fig. 2) The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the reversing switch lever. The L-side of the lever is pushed to turn the bit counterclockwise. CAUTION Never change the direction of bit rotation while operatihg. Turn the power switch OFF before changing the direction of bit rotation. PRECAUTIONS ON USING DRILL 1. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a live wire may make exposed metal parts of the power tool live and could give the operator an electric shock. 2. When mounting the drill bit or driver bit, insert it fully into the drill chuck and completely tighten the drill chuck with the chuck wrench. If mounting is not done porperly, it is very dangerous as the drill bit may slip or loosen during operation. 3. Do not wear gloves made of stu? liable to roll up such as cotton, wool, cloth or str........