PDF《810-12 • 810-15 • 912 • 915 • 275》

16 a.w.g. and no more than 20m /

65 ft in length. ? Never pull on the tool'

s connecting cable. ? This tool is not intended for the use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the tool by a person responsible for their safety. GUARANTEE AND REPAIRS This tool is guaranteed against faulty workmanship and materials for a period of

12 months from the date of purchase. Within this warranty period the manufacturers undertake, at their discretion, to either repair or replace any tool proved to be defective (proof of purchase will be required for verification). This guarantee is invalidated if the tool is opened, or modified in any way, or if adhesive formulations other than those supplied by the tool'

s manufacturer are used. Warranty claims attributable to improper, or careless, use or handling, and to normal wear, are excluded from this guarantee. The supplier'

s and manufacturer'

s only obligation shall be to replace such tools that are proved to be defective. Neither supplier nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use, or the inability to use, this tool. The user shall determine the suitability of this product for its intended use, and the user assumes all risks and liability whatsoever in connection therewith. The manufacturer reserves the right to improve or modify this product without prior notice. Do not connect to the main supply at this point! AVOIDING PROBLEMS ? Ensure that tool has reached temperature before operating. ? Do not leave tool switched on for long periods without use. ? If tool is not to be used for more than

40 minutes, switch off and restart when required. ? Never lay the tool on its side. Always use stand provided, the optional bench stand or the suspension unit. ? Only use adhesives designed for use with this tool. 1. Attach the tool stand. 2. Load the tool by inserting an adhesive stick into the rear. 3. Operate the trigger to feed the stick forward until resistance is felt. 4. Connect to main supply and switch on tool. 5. Wait

5 minutes to warm. 6. Operate the trigger to extrude adhesive until the stick has been completely drawn into the rear of the tool. 7. Insert a new stick into the tool. 8. To switch off the tool, disconnect from the mains supply.

1 2

2 3

4 For help with fault finding, please visit our website: For optional part, please visit our website: www.poweradhesives.com EN CONSIGNES DE SECURITE Ne touchez pas la buse ou la colle fondue a mains nues car elles sont chaudes - la température de fonctionnement de cet outil est d'

environ 200°C / 392°F (LT 120°C / 248°F). Gants de protection doivent toujours être portés. Manipulation négligente peut provoquer des br?lures de la peau. Si la colle chaude entre en contact avec la peau, plonger la zone affectée dans un bain d'

eau froide. Consulter un médecin si nécessaire. Outre ces consignes de sécurité, respecter les normes de sécurité prévues par la loi, la protection contre l'

incendie et toutes les réglementations en vigueur sur la prévention contre les accidents. Toute réparation doit être effectuée par une personne compétente, ayant les connaissances nécessaires en matière d'

électricité. Avant de procéder à toute opération d'

entretien ou réparation, débrancher l'

outil. En cas de doute, contacter votre fournisseur. ? ATTENTION C Cet outil doit être positionné sur son ........