PDF《Wind Tubes》

Wind tubes are a playful and inventive way to explore the effect that moving air has on objects, including constructions made from everyday materials.

It's fun to make things that fly out of or float in the tubes, and to adjust them to change the way they fly. ? E X P L O R A T O R I U M PIE Institute: www.exploratorium.edu/PIE PIE Institute shares a playful and inventive approach to teaching science, art, and technology. THINGS TO TRY Wind Tubes "This was an extremely friendly activity.You don't have to build something to start;

you can just grab an object and test it out." Workshop Participant Cut the flaps off the box, then cut the box in two pieces (you get two frames from each box) Cut triangles out of the flaps and tape them into each corner of the frame for support. TRY IT! Things to Try: Wind Tubes PIE Institute: www.exploratorium.edu/PIE Page

2 ? an acetate sheet, .0075 inch thick approximately

4 ft x

4 ft (122 cm x

122 cm) ? wood embroidery hoops,

14 in. (36 cm) ? transparent tape ? wooden spacers, three pieces,

2 in x

2 in x

6 in (5 cm x

5 cm x

15 cm) ? a fan,

18 in (46 cm), three speeds, with adjustable tilt head (we like the HoneywellTurbo series) ? scissors, hand drill, and a saw ? three 7" (18 cm) cable ties ? three large binder clips What do I need to float in the tube? ? thin (2 mm) and thick (6 mm) foamies www.craftsuppliesforless.com ? strawberry baskets and other plastic containers (CoolWhip containers work well) ? feathers ? skewer sticks ?Wiffle practice golf balls ? cardboard tubes ? pipe cleaners ? masking tape What do I need to build the tube? GET STARTED Things to Try: Wind Tubes PIE Institute: www.exploratorium.edu/PIE Page

3 Prepare the fan Set the spacers on the fan and place an embroidery hoop on top of the spacers. Trace a line where the hoop meets the spacers. Drill a hole in the other end of each spacer for a cable tie to pass through. At this point you may want to install a screen or mesh over the fan grill, to keep smaller items from falling through to the fan blades. Test a few kinds to make sure they don't block the fan's airflow. Cut an "L" shaped notch in the spacers using the line as a guide. Make sure your notch is twice as deep as your ring. Secure the spacers on the fan with the cable ties. (you might need to remove the grill of the fan to do this) MAKE THE TUBE Things to Try: Wind Tubes PIE Institute: www.exploratorium.edu/PIE Page

4 Roll the acetate into the embroidery hoops and tighten the screw on each hoop. Tape the inside and outside edges of the acetate with transparent tape. Place the tube into the notches on your spacers. Secure it with binder clips. The finished assembly should be quite stable. Tip: if you removed the grill of your fan, you will need to replace it before attaching the tube. TRY IT OUT Things to Try: Wind Tubes Pwww.exploratorium.edu/PIE Page

5 Make and test objects in the tube! Turn on the fan, place objects under the tube, and watch what happens when you let go! Things to Try Test common objects and materials. Make adjustments to these objects or create new ones using art materials. Design and build objects that spin, fly, or float in unusual ways. (modified toilet paper tube) Things to Try: Wind Tubes PIE Institute: www.exploratorium.edu/PIE Page

6 ? Experiment with different-sized tubes and wind sources.We tested squirrel cage fans and clear PVC pipe. TAKING IT FURTHER ? How do paper airplanes, helicopters, and parachutes behave in the wind tube? clear PVC tube squirrel cage fan wooden board hole Things to Try: Wind Tubes PIE Institute: www.exploratorium.edu/PIE Page