PDF《285》

20 to +

80 (with FKM seals) Viscosity range mm2/s 2.8 to

500 Cleanliness class to ISO code Maximum permissible degree of contamination of the pressure fluid is to ISO

4406 (C) class 20/18/15 3) Electrical Voltage type DC AC Available voltages 4) V 12, 24, 42, 60, 96, 110, 42, 110,

230 (ordering details for AC solenoids see below) 180, 205,

220 50/60 Hz Voltage tolerance (nominal voltage) % ±10 Power consumption W

35 C Holding power VA C

90 Switching power VA C

550 Duty Continuous Switching time to ISO

6403 ON ms

45 to

60 15 to

25 OFF ms

20 to

30 20 to

30 Switching frequency cycles/h Up to

15000 Up to

7200 Protection to DIN

40 050 5) IP

65 Insulation class VDE

0580 F H Max. coil temperature 6) °C

150 180 1) Suitable for NBR and FKM seals 2) Only suitable for FKM seals 3) The cleanliness class stated for the components must be adhered too in hydraulic systems. Effective filtration prevents faults from occurring and at the same time increases the component service life. For the selection of filters see catalogue sheets RE

50 070, RE

50 076 and RE

50 081. 4) Special voltages on request With electrical connections the protective conductor (PE ) must be connected according to the relevant regulations. 5) With assembled and locked plug-in connector 6) Due to the surface temperatures which occur on the solenoid coil, the European standards EN563 and EN982 have to be taken into account!

289 技术数 (如应用时超出这些参数,请咨询我公司!) 一般概述 安装位置 可选 环境温度围 -30至+50 (丁 橡胶密封) -20至+50 (氟橡胶密封) 重量 中央接线 单独接线 单电磁铁阀 4.4 (直流) ;

3.6 (交流) 4.3 (直流) ;

3.5 (交流) 双电磁........