PDF《Xxxxx Xxxxxx》

4 Installation Guide Installation of the OM-CP-WIND101A (OM-CP-PULSE101A-2 pos. terminal block) When installing the OM-CP-WIND101A, refer to the following: ? The anemometer should be mounted vertically in an open area, as high up as possible. Preferably on a pole. ? It can be mounted using a cotter pin on a 0.5 . (13mm) diameter mast with a #35 hole, 0.35 . (11mm) from the top. ? The anemometer is non-directional, and will measure wind blowing in any horizontal direction. To ensure the most accurate readings, adjust the position of the anemometer on the bracket so that it is level. ? Run the provided cable to the location where the data logger will be mounted, securing it roughly every 2'

. ? There are

4 mounting holes (0.2 (5mm) diameter spaced 2.5 (63.5mm square) on the weather resistant enclosure. Installing the Interface cable - OM-CP-IFC200 Refer to the Quick Start Guide included in the package. Installing the software Insert the Omega Software Flash Drive in an open USB port. If the autorun does not appear, locate the drive on the computer and double click on Autorun.exe. Follow the instructions provided in the Installation Wizard. Device Operation Connecting and Starting the data logger 1. Once the software is installed and running, plug the interface cable into the docking station. 2. Connect the USB end of the interface cable into an open USB port on the computer. Place the data logger into the docking station. 3. The data logger will automatically appear under Connected Devices within the software. 4. For most applications, select Custom Start from the menu bar and choose the desired start method, reading rate and other parameters appropriate for the data logging application and click Start . ( Quick Start applies the most recent custom start options, Batch Start is used for managing multiple loggers at once, Real Time Start stores the dataset as it records while connected to the logger.) 5. The status of the device will change to Running , Waiting to Start or Waiting to Manual Start , depending upon your start method. 6. Disconnect the data logger from the docking station and place it in the environment to measure. Note: The device will stop recording data when the end of memory is reached or the device is stopped. At this point the device cannot be restarted until it has been re-armed by the computer. Downloading data from a data logger 1. Connect the logger to the docking station. 2. Highlight the data logger in the Connected Devices list. Click Stop on the menu bar. 3. Once the data logger is stopped, with the logger highlighted, click Download . You will be prompted to name your report. 4. Downloading will offload and save all the recorded data to the PC. OM-CP-WIND101A-KIT

5 Product Maintenance Battery Replacement Materials: OM-CP-BAT105, Small Phillips Head Screwdriver, and 3/32 HEX Driver 1. Remove the data logger from the OM-CP-WATERBOX101A using the allen key. 2. Puncture the center of the back label with the screw driver and unscrew the enclosure. 3. Remove the battery by pulling it perpendicular to the circuit board. 4. Insert the new ba........